The shoes casual flat on the desktop or on the glass to see if stable shoes
When the shoe is placed on the desktop, it should immediately stop sloshing around.
7. Use the middle finger into the front tip soles below, Rocker height of the former view is appropriate
When Alice first toe just enough middle finger belly thickness, indicating that the toe of the former Rocker is appropriate. Before Rocker toe is too large, stable degrees lower; former Rocker is too small, fast soles wear, shoes deformation, foot fatigue.
8. Hold the shoes, soles and heels touching to see whether the smooth
The soles and heels lightly against the table (or counter) side, so that the side of the shoe up, view the sole contact area. With soles (soles at its widest point) and the entire heel touching the sides of the plane of the table as well. Otherwise, easy to deform and off the heel shoe.
9. The shoe flat on the table, whether viewed from both the front and rear direction correct
Head-start with a pair of shoes, look inside and outside edge of the sole from the tilt of the desktop size, should not very different, in order to maintain a consistent balance as well. Then from the heel of the shoe forward to see whether the heel of the shoe up and down vertically, as well as not to tilt toward the inside or outside.
10. erected with the index finger in the shallow shoes help outside view lateral parts of the upper height
The index fingertip contact with the inner sole of the shoe downwardly, so that the index finger near the outer ankle of the upper, second look at the index finger knuckle line, whether highly consistent with the upper lateral malleolus. General life with shoes, social etiquette shoes, fashion shoes, slightly lower than the index finger knuckle of the second line as well; after a low-cut sneakers and casual shoes are soft mouth to help catchy structure which can slightly lateral to help high The second index finger knuckle lines.
11. From the top view of the upper down to view the upper part of the symmetry, and the shoes I outline is deformed
Toe and heel midpoint in a straight line between the axis of symmetry, to see whether the parts on the upper symmetrical to each other inside and outside the symmetrical position does not move forward or backward as well. Shoes should be toward the mouth contour clasping shoes, smooth smoother were as good; twisted into a lotus-shaped poor quality shoes.
12. Learn the shoe outsole performance, choose the applicable outsole
There are several shoe outsole, according to the main raw material can be divided rubber sole of imitation leather, plastic substrates, and other, their performance is: rubber soles with a soft, flexible, non-slip, wear-resistant, heat-cold good. Just a little heavier texture.
Imitation leather sole, lightweight, stiffness, wear resistance, twists and turns. But less flexible, less slip. Plastic soles, wear resistance, good elasticity. But hard, poor heat resistance to cold.
